Message:

<p>[QUOTE=&quot;RonSanderson, post: 8079650, member: 77413&quot;]I used a Dremel tool and put on an attachment that is a sanding drum. I gently moved the spinning sanding tool around and around the inside of the hole until it was large enough to accept the coin. I was careful not to let it linger in any one spot to make sure the hole stayed round, but bigger.</p><p><br /></p><p>The paper edge ended up a little ragged, but I keep thinking I could take an exacto knife and carefully trim that. It would likely be better if I just took a spoon and ran its bowl around the inside of top edge to smooth and fold down the rough bits. I guess if it bothered me I would have done something by now.</p><p><br /></p><p>The enlarged hole is at bottom right in this photo.</p><p><br /></p><p>[ATTACH=full]1402798[/ATTACH][/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in