Message:

<p>[QUOTE=&quot;Publius2, post: 4653276, member: 105571&quot;]I&#039;ve thought a lot about ultrasonic cleaners.&nbsp; I use one in my shop to clean my eyeglasses, machine parts, etc.&nbsp; In thinking about its use for cleaning valuable and important coins, I agree with every caution already mentioned but I have a few other thoughts to share that go beyond the &quot;don&#039;t do it&quot; advice.&nbsp; My advice is more on the lines of &quot;If you decide to do it, maybe think about these things first...&quot;.</p><p><br /></p><p>I believe it is critically important to prevent the coin from interacting with anything other than the cleaning solution and whatever is used to suspend the coin in the cleaning solution.&nbsp; I have &quot;thought-experimented&quot; with such things as a machined coin edge clamp made of nylon, HDPE or other materials that are significantly softer than the coin, that can be machined, clamped on the edge securely, and that are inert (or mostly inert) to the cleaning solution utilized.&nbsp; The clamp needs to be somewhat secure on the coin since the ultrasonics will tend to vibrate it loose (it sure does with the screws on my eyeglasses!).&nbsp; The clamp needs to have a thickness that is slightly thinner than the coin to prevent a &quot;shelf&quot; that will capture crud falling off the coin.&nbsp; The clamp and coin need to be suspended from overhead into the solution such that the coin is vertical and the crud that is shaken loose drops down and away from the coin.&nbsp; If the coin and crud interact it will have negative effects on the coin.&nbsp; It might be beneficial to use one of the little propeller-type mixers to circulate the fluid over and above the natural circulation that the ultrasonics induce.</p><p><br /></p><p>Duration of cleaning should be short.&nbsp; I use about 10 seconds with my eyeglasses in a solution of water and two drops of Dawn dishwashing soap.&nbsp; The glasses come out with all the oils, greases, dust, etc. gone from even the deepest crevices.</p><p><br /></p><p>Of course, there is always the possibility that what lies below the crud is worse than the crud.&nbsp; And, there have been claims that the implosive bubbles that form on the surface during ultrasonic cleaning can damage the surface of the coin.&nbsp; I have never seen any evidence of this but then I have not tried it on high-grade coins.&nbsp; I would say experiment on inexpensive proof and MS Lincolns and look very closely at the surfaces before and after.&nbsp; If anyone pursues these ideas, please share your findings with us all.[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in