Message:

<p>[QUOTE=&quot;moneycostingmemoney, post: 2809853, member: 86367&quot;]That&#039;s a good question. Honestly short of sending it to an NDT lab I have no idea. The weight is within planchet tolerances but how much will a couple mills over the surface of a cent weight and what material was used? </p><p>I&#039;m sure it&#039;s not outside the realm of possibility to remove enough surface material from a certain area of this coin undetectable by the trained eyes of a TPG. Take that and a standard steelie sample to test with a spectrometer and compare. </p><p>If it would land in MS66 or higher it may be worth looking into.[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in