pulled vf 29 d wheat cent with clip from circulation!

Discussion in 'Error Coins' started by silentnviolent, Mar 3, 2016.

  1. silentnviolent

    silentnviolent accumulator--selling--make an offer I can't refuse

    Elation! :D

    How? I..... I dunno... WP_20160303_02_28_30_Pro.jpg WP_20160303_02_28_41_Pro.jpg WP_20160303_02_29_51_Pro.jpg

    Sorry for quality of photos but, I couldn't wait for a better set up!
     
    Markus1959 and dchjr like this.
  2. Avatar

    Guest User Guest



    to hide this ad.
  3. eric6794

    eric6794 Well-Known Member

  4. Treashunt

    Treashunt The Other Frank

    could be, but no Blakesley effect
     
    silentnviolent, ldhair and paddyman98 like this.
  5. Collecting Nut

    Collecting Nut Borderline Hoarder

    Nice little edge clip.
     
  6. David Setree Rare Coins

    David Setree Rare Coins Well-Known Member

    The clip is questionable but it's still a wonderful find!
     
    silentnviolent and Stevearino like this.
  7. Stevearino

    Stevearino Supporter! Supporter

  8. Kentucky

    Kentucky Supporter! Supporter

    With such a small clip, there would be little or no Blakesley effect.
     
    silentnviolent likes this.
  9. Jim M

    Jim M Ride it like ya stole it

    If there is a clip there is metal movement. I can not see how it would be possible for there not to be, there is a void of material, the material next to that void would attempt to move into that void. even if Blakesley is not obvious, you should still see metal flow lines close to the clip unless of course its so minor that its hard to even tell there is a clip to begin with
     
    Stevearino likes this.
  10. silentnviolent

    silentnviolent accumulator--selling--make an offer I can't refuse

    http://koinpro.tripod.com/Articles/CurvedClipDiagnostics.htm

    According to Ken Potter ,

    "However, the "Blakesley effect" does not always appear on the struck coin; most probably due to a heavy strike, and collectors must learn to recognize other diagnostics of a genuine clip. Look for tapering at the edge (especially at the extreme opposite edges or lips of the clip where it meets the raised rim) and notice how the metal flows and design details close to the edge stretch or elongate. Not all of these effects always occur and sometimes they are minimal but one or more of these diagnostics will generally be present on a genuine clip."

    This one does seem to be well struck.

    I will need to remove the funk collected around the inside of the rim.
     
  11. Kentucky

    Kentucky Supporter! Supporter

    Metal movement, yes, but metal doesn't flow like water, and such a small clip would cause very little metal "flow", hence little Blakesley effect.
     
Draft saved Draft deleted

Share This Page