Message:

<p>[QUOTE=&quot;John Burgess, post: 7596234, member: 105098&quot;]It&#039;s a bit more elaborate than a counterstamp. It&#039;s more along the lines of repoussè. Not as pushed out but it&#039;s pushed out from the back and then formed. I think both sides are done at the same time the back side pushes metal up and on the front side it forces it back down like a mold to leave the impression.&nbsp; I have an old hole punch tool that works like that with an Allan key on sheet metal you drill a hole and sandwich the sheet metal between the two dies and screw it down the bottom and top cut at the same time and punch out a circle without bending the sheet and leaves clean edges. It must be something along the lines of this device...Maybe a clamp and vise to do it.</p><p><br /></p><p>The G is for geometry in the center of the measuring tools, compass and 90 angle square ruler.</p><p><br /></p><p>This is one of the nicer ones I&#039;ve seen.[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in