Reply to Thread

Message:: [QUOTE="stldanceartist, post: 3094483, member: 13307"]If any of you have ever run across this issue, you'll understand my frustration with it...as well as my JOY at finally solving it once and for all (forgive me if this problem has already been solved, which, frankly, I'd be surprised if it hadn't): Older plastic coin tubes that have shrunk around the coins, making it impossible to get the coins out. I've come across this every few months or so - an older roll of BU cents stuffed into a thick plastic M. Meghrig & Sons that has essentially sealed itself around the coins.  Since I of course want to check the rolls for toners, gems, and varieties, I need to get those coins out.  But how? Last time, I tried the brute force method: 1) Pry cap off2) Hold roll in hand and hit bottom of roll with hammer (maybe one or two coins will pop out, but you always end up accidentally pinching your skin on the end and getting a very painful blood blister)3) Decide that isn't working, so pull out the X-Acto knife and tiny snips and start prying tiny pieces of the plastic away.  After about an hour or two, a bunch of bruises, scrapes, and a HUGE mess, you have your coins. Well, I just bought a few old BU rolls of Canadian cents with the same issue.  There are a few "Hanging" numeral die clashes that bring a premium (especially in BU) - so I have to check. Since I remember the agony of the process last time, I decided to sit down and think: "How the heck do I do this quickly and without banging the heck out of my thumbs?" Suddenly, that moment: EUREKA! I remember I have a smaller gauge pipe cutting tool in my electrician's toolbag.  I could use it to cut the tube into sections.  Maybe then I could put soft cloth on one end of the tube and use that to push the coins out! [ATTACH=full]781603[/ATTACH](Figure 1: Coin tube placed into small gauge pipe cutting tool.) After a few quick turns, the end pops off.  Coins are undamaged, as are my thumbs. [ATTACH=full]781604[/ATTACH](Figure 2: end of roll removed.) As I'm looking for something to protect the coins, and trying to find my screwdriver with the replaceable tip (because the wider end will do less damage) I have another moment of inspiration: "What would happen if I use my old vise grips to squeeze the plastic tube?  Would it deform enough to allow the coins to slide out?" So I get my vise grips out and give it a shot: [ATTACH=full]781602[/ATTACH](Figure 3: As you can see, the top of the tube is deforming outward.) Sure enough, the coins start sliding out: [ATTACH=full]781605[/ATTACH](Figure 4: Coins are unharmed and ready to be checked!) My reward for all this: 1959 BU Roll 1:3 Hanging 9's4 Double Hanging 9's 1959 BU Roll 2:3 Double Hanging 9's 1959 BU Roll 3:3 Hanging 9's3 Double Hanging 9's 1961 BU Roll:10 Hanging 1's4 with PL Reverses Good luck![/QUOTE]

Create my FREE Account!

Log in or Sign up

Reply to Thread

Useful Searches