Message:

<p>[QUOTE=&quot;Conder101, post: 778506, member: 66&quot;]Possibly, but I&#039;m not convinced yet.&nbsp; Are you saying that this mold would be used to create the printing block, or to be used to create an intermediary piece that would then be used to create the piece inserted in the printing block?&nbsp; I also have a couple of these printing blocks.&nbsp; The piece in the block has a reverse image of the coin for printing the picture.&nbsp; The mold in the eBay auction is also reversed so it would create a &quot;forward&quot; image of the coin.&nbsp; So the piece from that mold would not be suitable for a printing block.&nbsp; It would have to be used in turn to create a reversed image piece that could be mounted in the block.</p><p><br /></p><p>Also the actual relief of the surfaces of the pieces on the printing block is almost zero.&nbsp; The relief of the piece that would be produced by that mold would be much greater than that seen on the printing blocks.[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in