Message:

<p>[QUOTE=&quot;Insider, post: 2673618, member: 24314&quot;]Ordinary Fool posted: &quot;Should the dies clash every time if there is no planchet between them?&quot;</p><p><br /></p><p><span style="color: rgb(0, 102, 0)">I</span><span style="color: rgb(0, 102, 51)"> understand the question.</span></p><p><br /></p><p>I do not believe that with the ram correctly adjusted to dies correctly set in their zero Z position, that the dies should or would clash merely because no planchet was between them.</p><p><br /></p><p>I believe the hammer or anvil dies can possibly move out of their correct Z set point or the ram adjustment could move. If the ram journal/bearing wore, that could clash the dies if all else was good. Same for the crank&#039;s main bearing/journals.&quot;</p><p><br /></p><p><span style="color: rgb(0, 102, 51)">Could you please explain hammer &amp; anvil dies, Z set, ram journal, crank bearing, etc?&nbsp; Thanks!</span>[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in