Log in or Sign up
Coin Talk
Home
Forums
>
Coin Forums
>
Error Coins
>
Defective planchet or Struck in Rim Burr Quarter?
>
Reply to Thread
Message:
<p>[QUOTE="Lucky7, post: 957106, member: 15072"]The difference I see on my coin is that my quarter does not have the depressed middle section between the two lines. Instead, it is the same height as the rest of the coin. Here is the definition of III-C-14, Incomplete Straight Clip:</p><p> </p><p>" A coin struck on a planchet which was punched across a partial or incomplete shear of the end of the strip showing on the struck coin as an indented straight line partially closed by the metal flow." </p><p> </p><p>I can see the straight "blade" line is the lower line on my coin. It looks exactly like the A. Herbert picture of an Incomplete Straight Clip. </p><p> </p><p>Herbert says: " The sheared incomplete clip is likely to be deeper at one side due to the angle of the shearing blade, which is fixed at one end. As with the incomplete curved clip, the strike will tend to round and close up the blade marks. One of the earlier examples of this can be found on a 1795 large cent."</p><p> </p><p>I cannot find another good picture of an Incomplete Straight </p><p>Clip other than A. Herbert's picture. I will keep looking.</p><p> </p><p>The lower line is a straight line blade mark from the coin punch. The upper line is the "edge of the clad layer which broke off nearly parallel to the 'blade' line." The area between the two lines does not look like the rim of another coin definately or any kind of indentation other than the lower straight blade line. </p><p> </p><p>Herbert states "A strike through the rim burr is defined as: A coin which was struck with a partially sheared or detached narrow triangular piece of the rim metal sticking to the planchet, showing on the struck coin as a normal part of the surface, but separated from the planchet metal by a fine crack, or showing as a shallow indentation if the rim burr has fallen out." </p><p> </p><p>There is no indentation other than the blade line. If there were, then I think it would be in the middle of the two lines and then it might be a Strike Through the Rim Burr, III-K-8. Thanks for everyone's help in identifying this coin.[/QUOTE]</p><p><br /></p>
[QUOTE="Lucky7, post: 957106, member: 15072"]The difference I see on my coin is that my quarter does not have the depressed middle section between the two lines. Instead, it is the same height as the rest of the coin. Here is the definition of III-C-14, Incomplete Straight Clip: " A coin struck on a planchet which was punched across a partial or incomplete shear of the end of the strip showing on the struck coin as an indented straight line partially closed by the metal flow." I can see the straight "blade" line is the lower line on my coin. It looks exactly like the A. Herbert picture of an Incomplete Straight Clip. Herbert says: " The sheared incomplete clip is likely to be deeper at one side due to the angle of the shearing blade, which is fixed at one end. As with the incomplete curved clip, the strike will tend to round and close up the blade marks. One of the earlier examples of this can be found on a 1795 large cent." I cannot find another good picture of an Incomplete Straight Clip other than A. Herbert's picture. I will keep looking. The lower line is a straight line blade mark from the coin punch. The upper line is the "edge of the clad layer which broke off nearly parallel to the 'blade' line." The area between the two lines does not look like the rim of another coin definately or any kind of indentation other than the lower straight blade line. Herbert states "A strike through the rim burr is defined as: A coin which was struck with a partially sheared or detached narrow triangular piece of the rim metal sticking to the planchet, showing on the struck coin as a normal part of the surface, but separated from the planchet metal by a fine crack, or showing as a shallow indentation if the rim burr has fallen out." There is no indentation other than the blade line. If there were, then I think it would be in the middle of the two lines and then it might be a Strike Through the Rim Burr, III-K-8. Thanks for everyone's help in identifying this coin.[/QUOTE]
Your name or email address:
Do you already have an account?
No, create an account now.
Yes, my password is:
Forgot your password?
Stay logged in
Coin Talk
Home
Forums
>
Coin Forums
>
Error Coins
>
Defective planchet or Struck in Rim Burr Quarter?
>
Home
Home
Quick Links
Search Forums
Recent Activity
Recent Posts
Forums
Forums
Quick Links
Search Forums
Recent Posts
Competitions
Competitions
Quick Links
Competition Index
Rules, Terms & Conditions
Gallery
Gallery
Quick Links
Search Media
New Media
Showcase
Showcase
Quick Links
Search Items
Most Active Members
New Items
Directory
Directory
Quick Links
Directory Home
New Listings
Members
Members
Quick Links
Notable Members
Current Visitors
Recent Activity
New Profile Posts
Sponsors
Menu
Search
Search titles only
Posted by Member:
Separate names with a comma.
Newer Than:
Search this thread only
Search this forum only
Display results as threads
Useful Searches
Recent Posts
More...