Cent with Lathe Lines

Discussion in 'Error Coins' started by JCro57, Dec 9, 2019.

  1. JCro57

    JCro57 Making Errors Great Again

    So, is this from the die not being hubbed deep enough to the point that the lathe lines are removed?

    1996 D 1c lathe lines obv.jpg 1996 D 1c lathe lines rev.jpg
     
  2. Avatar

    Guest User Guest



    to hide this ad.
  3. cpm9ball

    cpm9ball CANNOT RE-MEMBER

    I don't know. I would think that the spacing (the pass of each lathe cut) would be much finer. Besides, isn't the lathe only used to transfer the design from the Galvano to the Master Hub? If that were the case, wouldn't all working dies be like this?

    Chris
     
  4. paddyman98

    paddyman98 I'm a professional expert in specializing! Supporter

  5. cpm9ball

    cpm9ball CANNOT RE-MEMBER

  6. Insider

    Insider Talent on loan from...

    That's a KEEPER!
     
    Kentucky likes this.
  7. 352sdeer

    352sdeer Collecting Lincoln cents for 50 years!

    Throw that sucker on a record player and see what tune it plays! Lol
    Good find! Put it in a 2x2 and enjoy.:woot:

    Reed
     
    PassthePuck likes this.
Draft saved Draft deleted

Share This Page