Message:

<p>[QUOTE=&quot;Publius2, post: 25827349, member: 105571&quot;]OK, this is probably a nit and if so I&#039;m sure I&#039;ll be called out on it.&nbsp; But I find this irritating and in the great American tradition of sharing all of our feelings, all of the time, here goes:</p><p><br /></p><p>This little half dime was recently slabbed by CACG.&nbsp; While photographing it and examining it under the 10X/30X stereo microscope, I noticed that the prongs on the obverse side at K12 and K4 had significant amounts of plastic flashing left on the prongs.&nbsp; This is leftover plastic from the injection molding process and it would normally cause the product to be rejected during QC either at the factory or, hopefully, within CACG&#039;s QC review.</p><p><br /></p><p>But it wasn&#039;t and here it is, unnecessarily obscuring part of the rims on what is already a small coin.</p><p><br /></p><p>I feel better already.</p><p><br /></p><p>[ATTACH=full]1647086[/ATTACH] [ATTACH=full]1647087[/ATTACH] [ATTACH=full]1647088[/ATTACH][/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in