Reply to Thread

Message:: [QUOTE="No_Ragrets, post: 26311563, member: 151874"]I know this has been covered already, but I'm looking for perhaps a different approach to a solution than listed previously. My 1838 large cent, as many have complained about before, does not fit snugly into the designated slot. I've seen recommendations for cutting custom "shims" but I very much dislike this approach. What other options do you have to table to perhaps remedy this issue? Seeing that it's a decent-enough condition EAC, I'd prefer to avoid anything that could result in damage over time such as paper-based fillers. Should I just try to carve out some foam inserts from other holders? As promised, here's some pics of my coppers (specifically the half cents), but they aren't necessarily straight-grade types of coins. Great details still, yes... but I'm ok with a "details" grade (if they were to be graded) when it includes actual visual details within the "details" part. That's the gist of my 7070. [ATTACH=full]1679827[/ATTACH] [ATTACH=full]1679828[/ATTACH] [ATTACH=full]1679829[/ATTACH] [ATTACH=full]1679830[/ATTACH] [ATTACH=full]1679831[/ATTACH] [ATTACH=full]1679832[/ATTACH] [ATTACH=full]1679833[/ATTACH] [ATTACH=full]1679834[/ATTACH][/QUOTE]