Message:

<p>[QUOTE=&quot;Oldhoopster, post: 2942272, member: 84179&quot;]A defect in the strip that wasn&#039;t caught when it was rolled to thickness. </p><p><br /></p><p>When the 3 layers are go through the cladding process, it&#039;s not hard to imagine uneven edges, or even a defect within one of the layers.&nbsp; What&#039;s unusual is that it wasn&#039;t trimmed away or caught in the inspection process prior to blanking. </p><p><br /></p><p>I also suppose it could be like a lamination where areas within the 3 layers did not properly bond, then separated after the blanking process, subsequently breaking off prior to striking (I don&#039;t think this is case for paddyman&#039;s example, however)[/QUOTE]</p><p><br /></p>

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in