Hello everyone, Just found this today. What degree would you say it is, less then 5% I would guess? Are they common? Worth hanging on to? I have not found a lot of them so not sure. Regards, Stan
Stan, Unless the reverse is also off-center then this is caused by a misaligned die as opposed to an off-center strike. Misaligned dies are very common. Either type of error would have to be extreme enough that it cuts off part of the design in order to command a premium.
Thanks. I was pretty sure it was not worth anything, but had to check. To answer your question, no, it is fine on the reverse. Regards, Stan
