The smallest coin minted in the USA?

Discussion in 'US Coins Forum' started by Allan Ashford, Feb 4, 2026 at 6:51 PM.

  1. Allan Ashford

    Allan Ashford Active Member

    7559707B-5B58-4506-BF17-7754D8C04723.jpeg BA3ECB73-8227-4C58-92E4-8B078701661B.jpeg Hi,

    Not had very much to post over the last few months, a combination of many converging issues. But back to it and this came into my possession today.

    A 2 and 1/2 Centesimos or “Panama Pill”

    Apparently used to make coins conform to a certain value.

    Seems a lot of effort for such a small amount, only 400, 000 minted but the skill is much to be appreciated I think, to have it made so small the dies must have been made by some high expert.
    Enjoy

    Allan

    Should have said the measurements are inch increments
     
  2. Avatar

    Guest User Guest



    to hide this ad.
  3. physics-fan3.14

    physics-fan3.14 You got any more of them.... prooflikes?

    No, not really... they made the model on a full size disk. They had a reducing lathe that worked on a ratio of gears. It took the original scale model and reduced it to whatever size they wanted, based on the gear ratio. They didn't have some guy in there carving a 10mm die!

    Why? The coin was 10mm. Your pictures against an arbitrary ruler tell us nothing.

    This coin was 10mm. The smallest US issue was 14 mm, the 3 cent silver coin. For those who know, this is a very small coin.
     
  4. -jeffB

    -jeffB Greshams LEO Supporter

    But it's thick relative to its diameter. The three-cent silvers (both varieties) were lighter than the Panama Pill, because even though their diameter was larger, they were much, much thinner.

    I'll continue to object when people say the Pill is "smaller" than the trime, because understanding conservation of volume was sort of my intellectual peak. :rolleyes:
     
    lordmarcovan and SensibleSal66 like this.
  5. benveniste

    benveniste Type Type

    I have an 1855/4 Octagonal California Gold 25 cent piece. It was clearly minted in the US and is about 10mm in size. (Heritage photo)
    upload_2026-2-4_20-56-0.png
     
  6. -jeffB

    -jeffB Greshams LEO Supporter

    I've seen little gold-washed St. Gaudens replica tokens much smaller than that, and I'm sure some of them had been "minted" in the US. I'm thinking we're discussing "struck at a US mint". (And not including the nails and nail-clippings and such that were destined only for TPG slabs.)
     
  7. physics-fan3.14

    physics-fan3.14 You got any more of them.... prooflikes?

    The key is in the wording or the intent... these were not US mint products. "Minted" implies striking by a mint.. an official government agency.
     
  8. mpcusa

    mpcusa "Official C.T. TROLL SWEEPER"

    Those are pretty small and could get lost very easily, even with the 1/20 and 1/10
    once coins which are slightly larger.
     
  9. Clawcoins

    Clawcoins Damaging Coins Daily

    For comparison, the 1917 McKinley commemorative $1 gold coin was 14.3mm and 0.0484 oz / 1.70 grams of gold.

    I believe the 1903 Jefferson / Louisiana Purchase $1 gold was the same size.
     
    Last edited: Feb 4, 2026 at 10:36 PM
    SensibleSal66 likes this.
  10. -jeffB

    -jeffB Greshams LEO Supporter

    Yep, they were the same as the standard-issue gold dollars from the 19th century.
     
    SensibleSal66 likes this.
  11. lordmarcovan

    lordmarcovan Eclectic numismatist Moderator

Draft saved Draft deleted

Share This Page