Acid treated buffalo nickels

Discussion in 'Coin Chat' started by Cheech9712, Feb 10, 2023.

  1. Cheech9712

    Cheech9712 Every thing is a guess

    I have a few extra acid treated buffalo nickels. Mostly P mint mark ones. Does anyone collect them. Willing to give some away. If you have any no dated buffalo nickels. I’ll swap them even. Also will tell how to cook them
     
    GH#75 and Heavymetal like this.
  2. Avatar

    Guest User Guest



    to hide this ad.
  3. paddyman98

    paddyman98 I'm a professional expert in specializing! Supporter

    What do you mean by acid treated?
    Did you use Nic-a-date on them?
     
  4. desertgem

    desertgem Senior Errer Collecktor Supporter

    The dealer(s) in Flagstaff,Az as well as some in NM sell them for incorporating into hatbands and other sourvenirs. Usually $1-5 each, although they trade by the bag usually.
    Jim
     
  5. desertgem

    desertgem Senior Errer Collecktor Supporter

    Ferric (III) Chloride is commonly used. Amazon has it at about $25 quart, other sizes available. I have used it for PC boards, brighten old corrode cents for art use, copper tubing before soldering, etc. CAUTION: It is bad stuff.!!! ..for chemists,etc,
    Jim
     
    manny9655 likes this.
  6. Paddy54

    Paddy54 Well-Known Member

    OWho would like a complete set of acid washed Buffalos...in fact one of the better sets done.. all dates,mm,and types ....I took it in trade years ago. I just dug this out two weeks ago to take to a show. 20230210_142212~2.jpg 20230210_142217~2.jpg

    I believe that 6this set came from Az. As the person aquired from did say he purchased it out west.
     
    Last edited: Feb 10, 2023
  7. tommyc03

    tommyc03 Senior Member

    Also used in horse tack quite often.
     
  8. Inspector43

    Inspector43 More than 75 Years Active Collecting Supporter

    I consider an acid treated (or any other method to bring out markings) to be a legitimate and collectable coin. The cold hard facts are it is a coin with markings as struck.
     
    Randy Abercrombie and Cheech9712 like this.
  9. Paddy54

    Paddy54 Well-Known Member

    This set was nicely done.."not nic a date" the entire side of the coin obv. & rev. Has been treated so its an even look , not a dark spot over a date. It sounds like it was done as Jim described.
     
    Cheech9712 likes this.
  10. Cheech9712

    Cheech9712 Every thing is a guess

    No vinegar
     
    -jeffB, eddiespin and paddyman98 like this.
  11. Cheech9712

    Cheech9712 Every thing is a guess

    That what I’m talking about
    people are 50/50 on that stuff. It’s just plain ass fun to me. People always wanna know how you do it
     
  12. tommyc03

    tommyc03 Senior Member

    I agree. This is especially necessary so as to avoid missing a possible over date, two feather variety or key date. There will always be value to these coins, albeit less than not having treated them but you can always sell a treated coin, if done properly and save for a better one of the same. They also make space fillers until you can afford a better coin.
     
    Cheech9712 and eddiespin like this.
  13. eddiespin

    eddiespin Fast Eddie

    You're doing it right. That's how you bring up the date and mint mark on these ones you can't tell. White vinegar works as well as anything for that. It'll smooth out the surface some, that's the only drawback. Not a big deal given these coins are shot to begin with. A date and mint mark is only going to add, not subtract, from the value. These coins aren't going to end up in the best collections, but who the hell cares? I agree with Tommy. While they're acid-treated, sure, they're still collectible.
     
  14. Inspector43

    Inspector43 More than 75 Years Active Collecting Supporter

    Stop and think about it. Ancient coins that we clean and identify are in a similar situation. We have little or no idea of what they are until we perform several steps to remove the dirt. Many times this includes some degree of chemical exposure.
     
    Cheech9712 and tommyc03 like this.
  15. -jeffB

    -jeffB Greshams LEO Supporter

    I used ferric chloride to etch PC boards back when I was a teen. For nickel restoration, I much prefer a white-vinegar soak. It leaves the coin with a uniform appearance, even though they clearly aren't "original surfaces". It doesn't produce the unsightly blob around the date that Nic-A-Date usually leaves.
     
    Cheech9712 likes this.
  16. Heavymetal

    Heavymetal Supporter! Supporter

    My LCS has ND rolls for $5
    I popped a couple open and 2 or 3 per roll were partial date
    Think I’m gonna grab a few next week
     
    Cheech9712 likes this.
  17. Scubalou

    Scubalou Well-Known Member

    I've been using vinegar for quite a while. I've soaked some coins for a couple of months. They don't always bring out a clear date but many do. Hey, it was worth a nickle when I started so what's the harm.
     
    eddiespin likes this.
  18. Cheech9712

    Cheech9712 Every thing is a guess

    That would be great for me.
     
  19. Cheech9712

    Cheech9712 Every thing is a guess

    That would be great for me.
     
  20. Heavymetal

    Heavymetal Supporter! Supporter

    Duly noted
     
    Cheech9712 likes this.
  21. Randy Abercrombie

    Randy Abercrombie Supporter! Supporter

    Why the heck not? They are always worth a nickel.
     
    Cheech9712 and tommyc03 like this.
Draft saved Draft deleted

Share This Page