This is a PCGS 8 holder with the barcode on the reverse. They were used from approximately October 1998 through February 2002. PCGS has appeared...
If they have rust then they are too far gone already.
The '52 looks amazing. A date set of silver (1932-1964) WQs will have tough to find toned coins prior to 1947 and after 1958. Those dates will...
I'm also in Connecticut and also under a mountain of snow. However, we have also lost our cable Internet connection so I am posting from my...
Based on the images, the coin is not worth a premium to me.
I'll have to disagree with you regarding all Barber halves being readily available in all grades. Most are ubiquitous in the lowest grades...
I may not be typical, but I would not pay a premium for an MS70 ASE.
I would not certify any of those. Once you are finished paying for postage and certification fees you will be in the hole and won't recover.
I've gone through my accounting for the last two years and these are the CBQs that I have sold- 1) 1825/4/3 PCGS AU53/CAC $3,950 where Greysheet...
One thing to keep in mind with the attrition rate is that these CBQs contain about 7% more silver in them than quarters issued from the early...
No offense intended or implied, but you were surprised or shocked by the prices quoted because you don't know the market. Problem-free CBQs with...
Not a good deal at all. These weigh approximately 5g each and 4oz (a full quarter pound) would have around 22-23 coins.
None of those coins is worth the investment of grading.
Works! Works! Works! It looks terrific.
These are easily obtained by ordering from any online retailer of camera equipment.
It might be the lighting used, but it appears that someone might have attempted to spiff this coin up at some point. If so, it is worth less than...
If I recall correctly, some of these newer ordinances are being pushed by private firms that stand to make a killing on the regulations. Again,...
I'm not writing about "juicing" at all. The goal should be the most accurate representation of the coin in-hand. If producing the most accurate...
The most direct method of manipulation for an otherwise satisfactory image, in my opinion, is to edit the image using software after acquisition.
Stop right there. You don't know enough. Do not be penny-wise and pound-foolish.
Separate names with a comma.
